Jenn-Air JMW9527DAS Use & Care Manual page 6

O00KING
Entering the day of the week:
1. Press Setup pad=................. ,
2. Sebct CHock. Setup"
3. Sebct Day.
4. Sebct Back or Fwd to scroll through the days.
5. Se.,lect S et.
6. To exit the Setup mode, press Setup.
Canceling the clock/day of week display:
1. Press Setup pad. ......... ,
Setup :
2. Press CHock.
3. Press the Down arrow to scroll to the next screen.
4. Sebct DbaMe.
5. Sebct Off to turn the chock dispiay off, or sebct On to turn
the chock dispiay on.
6. Sdect Set.
7. To disaMe the day of week dispiay, sebct OFF or sebct ON
to turn the weekday dispiay on.
8. Sdect Set.
9. To exit the Setup mode, press Setup.
To set the clock for a 12 or 24 hour format:
The chock can be set to dispiay time in either a 12 hour or 24
hour format.
1. Press the Setup pad. .........
\
2. Select Clock.
Setup
3. Use the down arrow to scroll to the next screen.
4. Select 12/24 Hr.
5. Select 12 Hr or 24 Hr.
6. Select Set.
7. Press Setup to exit Setup mode.
Timers
Setting the Timers (Timer 1 or Timer 2):
1. PressTimer 1 orTimer 2. / TIMERt \
2. SebctTime. \ on/Off
3. Press one of the displayed times using the Quickset pads,
or press the number pads to enter the desired time.
Note: Each press of the displayed time choices adds
additional time. For example, pressing "10 rain" three times
provides 30 minutes on the timer (0:30).
4. Press Enter.
Changing the amount of time entered once the
Timer starts:
1.
2.
Press the Timer 1 or Timer 2 pad ONCE.
Press the displayed times on the Quickset
pads until the desired time is entered.
OR
TIMERI
On / Off
\ ......
3. Press the number pads to enter the new desired time.
4. Press Enter.
Caneeming the Timer:
1. Press the Timer 1 or Timer 2 pad 1WICE. TIMER1
OR On / Off
\
2. Press the Timer 1 or Timer 2 pad ONCE and
Press CANCEL on the Quickset pads.
Changing the Timer format:
The Timers can be set to display hours and minutes (HR/MN)
or minutes and seconds (MNiSEC}.
1. Press the Setup pad.
Setup
2. Select the Down arrow and .... ....
scroll until you see Timer Format.
3. Select Timer Format.
4. Select HRIMN or MNISEC.
5. Select Set.
2.
3.
6. Press Setup to exit Setup mode.
(}hanging the Timer beeps:
The signal beeps for Timer 1 and Timer 2 can be changed.
The options available are two beeps every thirty, seconds, two
beeps every sixty,seconds or 1 beep only. The default setting
is One Beep. .......................
1. Press the Setup pad. Setup
Select the down
arrow to scroll down until "Tones" is displayed.
Select Tones.
4. Select Timers.
5. Select the desired timer beep format (2-30 sec., 2-60 sec.
or 1 Beep}.
6. Select Set.
7. Press Setup to exit Setup mode.
5