Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Before cleaning, make sure all controls are off and the cooktop is
cool. Do not use oven cleaners, bleach or rust removers.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
/
/
E
D
C
D
C
Left miniwok burner
Right
and Center
burners
A. Burner cap
B. Alignment
pins center and right burners only)
C. Igniter
D. Burner base
E. Gas tube opening
Gas tube opening:
Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Keep spillovers out of the
gas tube by always using a burner cap.
To Clean:
1. Remove the burner cap from the burner base and clean
according to "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden
toothpick.
If the burner needs to be adjusted, contact a
trained repair specialist.
4. On the center and right burners, replace the burner cap,
making sure the alignment pins on the cap are properly
aligned with the burner base.
c
LF_J-u iJ u---u_
..........................
B
5=
A. Incorrect
B. Correct
Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
B
A. 1-11/2"(25-38 mm)
B. Burner ports
Burner ports: Check burner flames occasionally
for proper size
and shape as shown above. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
6
Advertisement
Table of Contents
