Sealed Surface Burners; Surface Grates - IKEA HOB250 Use & Care Manual

Su ce Butanes;
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Before cleaning, make sure all controls are off and the cooktop is
cool. Do not use oven cleaners, bleach or rust removers.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
A
To Clean:
1. Remove the burner cap from the burner base and clean
according to "General Cleaning" section,
2. Clean the gas tube opening with a damp cloth.
3. Clean clogged burner ports with a straight pin as shown, Do
not enlarge or distort the port, Do not use a wooden
toothpick, If the burner needs to be adjusted, contact a
trained repair specialist,
4. Replace the burner cap, making sure the alignment pins on
the cap are properly aligned with the burner base.
C
A. Burner cap
B. Afignment pins
C. Igniter
D. Burner base
E. Gas tube opening
E
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening, keep spillovers out of the
gas tube opening by always using a burner cap.
B
A. 1-11/2'' (25-38 mm)
B. Burner ports
Burner ports: Check burner flames occasionally for proper size
and shape as shown above. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
A. Incorrect
B. Correct
5. Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
Single Grate (HOB 450)
The X-shaped slot on the grate must be positioned on the raised
flange as shown.
A
C
B
\
\
\
\
\
\.
\\
\\
\\
\\
A. Grate
B. X-shaped slot
C. Burner cap
D. Raised flange