Clearing Blockages - Hoover U5184-900 Owner's Manual

PROBLEM
Dirt inside dirt
cup stops
spinning
Powered hand
tool brush roll
won't turn
!POSSIBLE CAUSE
Too much pressure being
applied to tool
Broken or worn belt
SOLUTION
Continue using tool applying light
Replace belt
Clearing blockages
Disconnect cleanerfrom electrical outlet
Low suction or pick up may be due to a
blockage in the system. The light on the right
of the base(when lookingat the front) will illu-
minate if there is a blockage in the machine.
The light on left sideof the basewill illuminate
when brushbar i s switched o n, Refertothefol-
lowingsteps to check for blockages continu-
ing with each step until the blockage is
found:
Ifa blockage occurs during floor cleaning:
Turn cleanerOFFand disconnect f rom electrical
outlet
1. Check fullness of dirt cup and filter
assembly; empty cup and clean filters if
needed.
|
Checkbrush roll Checkhosetube
2. Turn cleanerOFF 4. TurncleanerOFF
and unplug, and unplug.
3. Turn cleaner over 5. Remove hose
and clear blockage from tube. Clear
from brush roll.
blockage from
Return cleaner to tube. Also, check
operating
position,
hose for blockage.
Turn cleaner back
on and continue
cleaning.
12