Related Manuals for Hoover U5180
Summary of Contents for Hoover U5180
-
Page 1: Operating The Cleaner
® ® Owner’s Manual ENGLISH pp. 1-12 ESPAÑOL pág 13-19 FRANÇAIS p. 20-26 This product was designed for easy assembly (see page 3) Review this manual before operating the cleaner www.hoover.com... -
Page 2: Table Of Contents
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot). -
Page 3: Assembling Cleaner
If you need any assistance: Visit our website at www.hoover.com. Click on the “Service” button to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only) OR Call 1-330-499-9499 to speak with a representative in our Consumer Response Center. -
Page 4: Position Tools
Position tools Place smaller diameter end of wand (A) into bottom of rack. Snap wand into clip at top. Repeat with other wand. Crevice tool (B) fits into one of the extension wands. Snap combination tool (C) and pow- ered hand tool (D) into storage areas on back of cleaner as shown. -
Page 5: Carrying Cleaner
Carrying cleaner Handle positions Carpet height The handle of your cleaner has adjustment The cleaner can also be moved by three positions; upright for storage using the carrying handle. The cleaning of carpet and rugs and when using cleaning tools; takes place at the nozzle (A). -
Page 6: Cleaning Tools
Cleaning tools 2-10 2-11 Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas. The cleaner is ready for tool use when handle is in upright position. CAUTION: The agitator continues to rotate while cleaner handle is in upright position. -
Page 7: Cleaning Filters
Holding dirt cup over trash recepta- Place bottom of dirt cup in first. How to empty cle, press dirt cup door release but- Pivot cup into cleaner body. Disconnect cleaner from electrical ton (C) to open dirt cup door (D). outlet. -
Page 8: Replacing Belt
HOOVER belts with Using a coin, turn the two slots (A) your cleaner. When purchasing a on either side of the hood as shown. new belt, ask for HOOVER part No. 38528040 (belt package part No. 40201190). -
Page 9: Lubrication
Lubrication When purchasing a new agitator, The motor is equipped with bear- When to replace ask for HOOVER part No. ings that contain sufficient lubrica- When agitator brushes are worn, the 48414113. tion for the life of the motor. The agitator should be replaced. -
Page 10: If You Have A Problem
Do not send your cleaner to The to cool for 30 minutes (this will vicing (see “Service” section). Hoover Company in North Canton for reset the thermal protector) service, this will only result in delay. Problem: Cleaner/tools won’t pick up... -
Page 11: Clearing Blockages
Clearing blockages Disconnect cleaner from electrical outlet. Low suction or pick up may be due to a blockage in the system. Refer to the following steps to check for blockages continuing with each step until the blockage is found: 1. Check fullness of dirt cup; empty if needed. -
Page 12: Warranty
This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Sales and Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from state to state.