Table of Contents
Advertisement
Available languages
Available languages
CARPETHEIGHT
The cleaning
of carpet
and rugs takes place at
the nozzle (A).
When it is necessary to
raise
and
lower
the
nozzle
for
various
carpet
pile
heights.
slide the nozzle control
knob (B) to the desired
setting.
ADJUSTMENT
HANDLEPOSITION
For
ease
in
sliding
knob, the handle should
be
in
the
upright
position (C).
The
nozzle
will
not
move into the adjusted
position
until
the
cleaner
handle
is
lowered to the operating
position (D).
SETTINGS
For maximum
cleaning performance,
the following
carpet height settings are recommended:
• Lowest setting:
or all types of carpet,
Notei If the
cleaner
is difficult to push, slide knob to the next
higher setting.
° Higher settings: for very deep pile carpet where
easier pushing effort is desired, while maintaining
good cleaning performance,
HIGH
HARD
FLOOR
CLEANINGLIGHTWEIGHT
FLEXIBLERUGS
Stand on one end of rug and move cleaner toward
other
end or edge. Before
reaching
edge, push
dOWn on handle. This will lift up the nozzle (front of
cleaner) as shoWn and wilt prevent rug from clinging
to cleaner. Continue to lift up nozzle so that when
you have reached the edge, it is completely off the
rug, Move cleaner back to start again, lower nozzle,
and use only forward strokes.
STAIR CLEANING
2,t2
Lift vacuum
by Stair Cleaning
Handle and
position
on stairs. Clean forward
to back. Never
leave the vacuum
standing
on stairs when
not
cleaning.
Advertisement
Table of Contents
