Hoover UH30015 Owner's Manual page 12

Check AgitatorShield
Because your cleaner picks up so well. we strongly recommend you check for debris aocJJmulation under the
agitator shield each time you clean the filters.
Removing debris under the shield v_]] help maintain your cteaner's excellent pick Up and suction. Remove
debris as fofloWs:
1, Disconnect cleaner from electrical outlet.
2. Check for dir[ accumulation by removing bottom plate (Fig. 4-10), removing agitator (Fig. 4-tl), and lifting
agitator shield (Fig. 4-13).
3. Remove any debris and replace shield, agitator and bottom plate (Figs. 4-13 to 4-15).
HEADLIGHT: H ow to Replace
(Available on select models only)
A WARNINGA
To reduce the risk of electric shock, unplug
vacuum before cleaning or servicing.
RemovingLens
4.7 Using a screwdriver, remove the two screws as
shown and lift off lenS.
installingBulb
4.8 Pull old bulb straight out of socket. Push new
bulb straight into socket until locked in place.
Excessive force is not required.
ReplacingLens
4.9 Reposition lens and secure with the two screws,
, , !
BELT:
Howto Replace
The belt on your HooveP cleaner causes the agLtator
to rotate and is important for the effective operation
of the cleaner. The belt is located under the bottom
plate of the cleaner and should be checked from time
to time to be sure it is in good condition,
CAUTION
To reduce the risk of injury from moving parts,
unplug vacuum before servicing,
Whento Replace
To check belt, remove bottom plate as shown in
"How to raplace". Replace belt if it is stretched, cut
or broken.
Howto Replace
Place handle in low position and turn cleaner over
so bottom side is up.
4.10 Remove the 4 screws as shown with a Phillips
screwdriver.
Lift off bottom plate (A).
....... 4._i Remove agitator brushroll and used belt.
Discard used belt.
"t2