Hoover UH30015 Owner's Manual page 13

4.12 With leltering on outside ofbelt
and positioned
as shown in box on (D), slide new belt over motor
pulley (B).
4,I3 Insert agitator through belt and place belt in
belt guide (C) on agitator.
Should the agitator shield (D) become dislodged
while replacing the be]t or the agitator, reposition it
as shown noting the placement of its belt guide (E).
4.14 Grasp agitator firmly and fit it into position by
first sliding end opposite the belt into the rectangular
slot (F) on side of cleaner, Pull other side of agitator
(G) into place.
Tum agitator making sure belt is not pinched
bet',eeen agitator and agitator shield.
4,15 Reposition bottom plate and 4 Phillips head
screws, lighten screws securely.
THE AGITATORBRUSHROLL: How to Replace
CAUTION A
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Whento Replace
VCn, en agitator brushes are worn, the agitator should
be replaced.
To check condition of brushes, disconnect cleaner
from electrical outlet.
4.16 Move edge of a card across bottom plate while
turning agitator. To maintain cleaning effectiveness,
replace agitator if brushes do not touch card.
Howto Replace
Remove bottom plate, belt and agitator following
directions in "BELT: How to Replace* section begin-
ning with Fig. 4-10. Discard old agitator.
Continue following the directions in "BELT: How to
Replace" section to repos[tion belt, new agBator and
bottom plate.
"13