GE JGBS04 Owner's Manual & Installation Instructions page 42

Installation Instructions
[]
INSTALL THE ANTI-TIP DEVICE (cont.)
For wood construction, drill a pilot hole at an
angle of 20 ° from the horizontal. A nail Or awl
mag be used if a drill is not available.
Mount the Anti-Tip device with the screw
provided.
For cement or concrete construction, gou
will need a 1/4" x 1Vz" lag bolt and a 1/21' O.D.
sleeve anchor, which are not provided. Drill the
recommended size hole for the hardware.
Backof
range
Install the sleeve anchor into the drilled
hole and then install the lag bolt thr0iJgh the "
device. The bolts must be properlg tightened
as recommended for the hardware.
Slide the range against the wal ,and check for
proper installation bg grasping the front edge
of the cooktop and carefullg attempting tOtilt
the range forward. The bracket should stop
the range within 4 inches, tf it does not. the
bracket must be reinstaJ ed.
WHEN ALL HOOKUPS ARE COMPLETED
Hake sure all controls are left in the OFF
position. Make sure the flow Of combustion and
ventilation airt0 the range is unobstructed.
CONVERTTOLP GAS Ior convert beck to
natural gas from LP)
This range leaves the factorg set for use with
natural gas: Ifyou want to convert to LP gas, the
conversion must be performed bg a qualified LP
gas installer.
The conversion instructions and LP'orifices can be
found attached to the range next to the pressure
regulator.
Keep these instructions and the orifices in case
gou want to convert back to natural gas.
42