GE JGBS04 Owner's Manual & Installation Instructions page 38

Installation Instructions
i i
[] LIGHT THE PILOTS (cont.)
[] Adjust the Surface Burner Pilots if Necesserg
CAUTION
- Make surethesurface
burner control knobs are in the OFF position
before attempting to adjust the pilots.
1. Raise the cooktop.
2. Locate the pilot adjustment screw. It can
be accessed through the small hole near
the center of the manifold panel.
.
To adjust, use a blade-tgpe screwdriver
with a shaft diameter of less than or equal
to 3/16",Turn pilot adjustment screw until
pilot flame is 5/16" high. Do not reduce the
flame to Jessthan 5/16" or pilot outage may
occur. A pilot flame burning higher than
recommended mag generate soot (carbon
black) on the bottom of gour cooktop,
[] Light the Oven Pilot
1. Ensure the top burners are lit before
attempting to light the Oven pilot (turn them
off after gou have tit the oven pilot).
2. Remove the oven door. See Lift-Off Oven
Door in the Care and cleaning of range
section.
3. Remove the oven racks.
[] Light the Oven Pilot Icont.!
4. Remove the oven bottom. To remove:
• Remove knurled screws holding down
rear of oven bottom.
• Grasp oven bottom at finger slots on
each side.
• Lift rear of oven bottom enough to clear
the lip of range frame: then pull out.
J
5. Locate the pilot in the back of the oven
bottom. The pilot is attached tothe left side
of the oven burner.
Shield.
(onsome
Pilot
6. To light the oven pilot, push in and hold the
oven control knob while ighting the pilot
With a tong match or match holder. Once
the oven pilot is lit, continue holding the
oven control knob for one minute before
releasing.
No adjustments are required for natural
gas. If the range is connected to LP gas,
contact the person who installed gout
range or made the conversion. If pilot
flame does not stag lit, repeat this step.
38