Adjusting The Needle Swing - Brother VX1140 Instructions Manual

5. ADJUSTING THE NEEDLE SWING
STANDARD
When the stitch width knob is set at "S", [he needle swing shou]d be 0.05 mm or less when the needle is moving down from the needle
alate to its lowest position. When the needle is moving up from its lowest position to the needle plate, the needle swing should be 0.15
mm or less Both sides of the needle plate hole should have these ¢Eearances.
ADJUSTMENT
I, Loosen the i_vo zigzag base assembly screws.
2. Align the upper shaf_ _ear and the zigzag cam gea_
3. Tighten lbe two zigza_ base assembly screws.
NOTE
To coFrecl _he needle swing, align the upper shaft g_ar and the zigzag cam gear at an,/two points.
®
X