Adjusting The Clearance Between The Needle And The Shuttle Hook (Shuttle Race Position); Standard - Brother VX1140 Instructions Manual

3. ADJUSTING THE CLEARANCE BETWEEN THE NEEDLE AND THE SHUTTLE
HOOE (SHUTTLE RACE POSITION)
STANDARD
_. Theclearance between the needle and the shutt]e hook should be between 0.02 and 0.1 ram.
2. The shuttle race should be posl ioned correc ly wL h respee o he urnmg dlrec ion of he shuLLle race.
ADJUSTMENT
1. SeL the needle position selector to "M" and the stitch width knob LO"0".
_. Turn the baJ_nce wheel to set the needle and the shuttle hook to the correct timing position.
3. Use a screwdriver to _um the needle bar supporter stud slightly to either the right or left and a_just the crearance between the needle
and the shuttle hook.
NOTE
A line through the center of the needle should pass through the center of Lhe shuLtle hook shaft.
©
@
O_O2-_lmrn
®
-3-