Table of Contents
Advertisement
& S_a_on
Service
& Troubleshooting
Guide ' Home Generator
Systems
_
Model
1938 (I 0kW) Generator Assembly
Removing
The Meccalte-Generator
Roof Removal
CAUTION:
Before enclosure disassembly:
' Turn
Switch
"OFF!!
• Turn Fuel ,OFF,
,Remove
5 Amp
Fuse
The roof is secured to the "Standby" enclosure with four
nuts that thread on studs welded to the structure of the
roof, as shown in figure 45.
The muffler itself is supported
by four metal brackets. These
brackets bolt to flanges that have been welded to the
muffler and fit over four machine screws that secure the
metal cover on top of the generator
housing. Two brackets
are shown in figure 47.
• Remove the nuts and hardware shown above.
• Lift the roof from the enclosure.
Muffler
Box Removal
To gain sufficient clearance to extract the muffler box it is
necessary to remove the the exhaust grill panel.
• Remove the four mounting screws that secure the
exhaust grill to the enclosure. One side of the grill is
shown in figure 46.
• Remove the four brackets and retain the hardware.
NOTE:
All four brackets must be removed.
46
Advertisement
Table of Contents
