Assembly - Ariens 911403-WAW 1034 Owner's Manual

Check allhardware atregular intervals,
especially blade attachment bolts. Keep all
hardware properly tightened.
An extension spring, when e xtended, stores
energy and can bedangerous. Always use
tools s pecifically designed forinstalling or
removing anextension spring. Always
compress orextend springs slowly.
Before tipping unit, remove fuel and battery (if
equipped).
Use extra c are w hen l oading orunloading
unit onto trailer ortruck.
Ensure all w heel blocks, jack stands and tie
downs will s upport unit d uring maintenance.
Replace worn-out mufflers immediately.
Continued use could r esult infire or
explosion.
Sharp edges can cut o ramputate fingers ora
hand. Wrap b lade o rwear sturdy gloves to
service.
Only r eplace blades. NEVER straighten or
weld b lades.
Use o nly r eplacement parts designed for y our
unit. See your Ariens Dealer.
Allow e ngine tocool before storing inany
enclosure.
ALWAYS clean u nit before extended storage.
See engine manual forproper storage.
DO NOT s tore u nit i nside abuilding with fuel
inthe fuel tank w here any ignition sources
are present.
Use only a ccessories which h ave b een
approved by Ariens and are properly
installed.
Use o nly a ccessories orattachments that are
designed for y our unit a nd that can beused
safely onyour terrain.
Check attachments frequently and replace
worn o rdamaged components with
manufacturer's recommended parts.
=1 i:] 4,d
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
CARTON CONTENTS
1
2
1. Mower Unit
2. Literature Pack with
Installation Hardware
Figure 3
ASSEMBLY
1. Remove all packing materials and straps
from unit.
2. Remove one pair of nuts and bolts from
the handlebars.
3. Rotate the handlebar into the operating
position and connect the two braces to
the handlebars.
4. Replace the nuts removed in step 1 and
then tighten all four nuts.
GB-9