Ariens 911403-WAW 1034 Owner's Manual page 13

Lock P in
Flats
Spacers
Figure 7
Align t he open e nds o fthe spacers with the
flats o nthe caster spindle and remove the
spacers one atatime u ntil enough are left a t
the bottom f orthe desired cutting height.
Remove the lock p in while s upporting the
caster arm. Lower the arm ontop ofthe
remaining spacers. Put t he spacers that were
removed inthe caster spindle above the
support tube asshown (Figure 8).
Reinstall the lock p in into the top hole and flip
over the lock r ing tosecure the remaining
spacers and pin.
NOTE: Set b oth w heels atthe same h eight
foralevel cut.
Remove the
spacers from
the stack.
Secure
spacers
above the
caster arm
with the
lock p in.
Figure 8
Forward Drive Control
(Lower Right Hand Control)
CAUTION: Unit will move at
engine start if the wheel drive
controls are engaged. ALWAYS
release the wheel drive controls
before starting unit.
NOTE: Engine must be running for wheel
drive to propel unit.
To drive forward:
Hold the parking brake lever against the
handlebar and slowly squeeze and hold the
forward drive control. Hold the forward drive
control against the handlebar for fastest
speed.
To stop:
Release forward drive control.
GB - 13