Speaker Preparation; Falling Prevention - Sharp HT-SB600 Operation Manual

Speaker preparation

To mount the speaker on the wall
Caution:
●
Be very careful to prevent the speaker [ 2.0 kg (4.41 lbs.)]
from falling when mounting on the wall.
●
Before mounting, check the wall strength. (Do not put
on the veneer plaster or whitewashed wall. The speaker
may fall.) If unsure, consult a qualified service
technician.
●
Mounting screws are not supplied. Use appropriate
ones.
●
Check all wall mount angle screws for looseness.
●
Select a good location. If not, accidents may occur or
the speaker may get damaged.
●
SHARP is not responsible for accidents resulting
from improper installation.
Driving screws
SHARP designed the speakers so you may hang them on
the wall. Use proper screws (not supplied). See below for
size and type.
3.2 mm (1/8")
5 mm
(3/16")
Min. 22 mm (7/8")
Fixing wall mount angle
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal
position as below.
509 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
8-9 mm (3/8")
Wall surface
3
Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall
surface.
8-9 mm (3/8")
Wall surface
9 mm (3/8")
44 mm
29 mm
Pattern paper
32 mm (1-1/4")
32 mm (1-1/4")
4
Screw the wall mount angle to the wall as shown in
the illustration. (Total screw is 8 pieces)
Wall mount angle
Wall mount
angle
Wall surface
(screws x 4)
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
Installing the speaker
1
Align the wall mount slot at the speaker to the wall
mount angle.
2
Slot the speaker into the wall mount angle.
3
Fix them securely.
Wall surface

Falling prevention

Safety wires (not supplied) are useful to prevent the
speaker from falling off the table.
Loop the safety wires (not supplied) into each hole as
shown and tie the safety wires to the LCD TV stand.
E-8
Wall
(screws x 4) surface
Wall surface
Wall
mount
angle