Table of Contents
Advertisement
SPECIAL
RESET
EXIT
Submenu for advanced camera functions:
USER PRESET
PRIVACY
DAY/NIGHT
SYNC:
COMM ADJ
IMAGE ADJ
END
Reset of the camera parameters to factory defaults.
Return to CAMERA menu.
Not supported by EPTZ 100
Keep OFF setting, privacy mask setup is done in the
PRIVACY MASK menu, available in the main menu
Modes of the day/night switching:
B/W : black/white (night) mode, IR cut filter switched off
COLOUR: colour (day) mode, IR cut filter switched on
AUTO1: day/night switching with short delay time
AUTO2: day/night switching with longer delay time
Synchronization mode, fixed at INTERNAL mode
Communication settings for camera interface
ATTENTION:
Do not change any value in this submenu!
Keep default settings:
CAM ID
DISP CAM ID OFF
BAUD RATE
UART MODE 8-N-1
RET PKT
If these settings are changed for whatever reason, the
communication between dome electronics and camera
menu will be broken. In this case consult APPENDIX C
for recovering camera module communication settings.
FREEZE: Store ("freeze") current video image
H-REV: Flips the image horizontally
V-REV: Flips the image vertically
SHARPNESS: Image sharpness adjustment in the range
1 ~ 30
COLOUR GAIN: Colour saturation adjustment in the
range 1~ 50
Return to CAMERA ADVANCED SETTING page
30
0
38400
ENABLE
EPTZ100_ma_en_rev03.doc
Advertisement
Table of Contents
