Mounting The Motor - Craftsman 113.248340 Owner's Manual

B
Assembly (continued) .....................
Mounting The Motor
1, From the loose parts find the folk)w_ng l_m_v
Item Description Qty.
A Motor .................................................. 1
B M8 x 35 hex cap botts (approx 1.3/8°_ 4
C M8 Washers ................ 8
D Rubber gremrnets ............. 4
E M8 _ockwast_ers
....
4
F M8 nuts ................................ 4
G V Beit 1
2 ]o mount motor piece four rubber grommets over
holes _r_stand top NOTE Use of rubber grommets _s
essentia! for eiirmnatinq excesswe vibrahon Place
motor over rubber grommets ahd fasten to stand top
with tour hex i_ead bolts eight washers four tockwash
ers. and _'Ou_ hex nuts. as shown Do not t_ghten _d this
hme
ii _ if ,
,-. _ ............. i _ _,_ o _I .__i_-_-
3, ARign the tns_de edge of the motor pulley with inside
edge of the large pulley usin_;l a straight ed(,le Usinq a
3ram hex "L" wrench adlust one or botl_ pulleys by
loosening the set screw and moving the pulley(s) unhl
they Sine up with each other Tighten set screws
r i 1111 i J t , rll ill i
4 Place V belt over both pulleys
5 Tension V belt by mowng moler away from tl_e saw
body and tighten the motor mount nuts (Do not over
tighten nqotor mount bolts Tighten just enough to ten
sion belt,} Belt is p_:operly tensioned when linger
pressure between the two pulleys causes approxi
matety 1/2" deflection
12
i ii, u •
1 v
L ;