Installing Drawers - Craftsman 113.198610 Owner's Manual

INSTALLING DRAWERS
FOR MODEL NO. 113.198610
Tools needed: 7/16" wrench or socket, medium
screwdriver.
1. Locate one (1) front support, one (1) upper
support, and three (3) rear supports.
2. Slide the upper support into the top of the front
support so the top and side holes line up. Then
assemble to the front and rear skirts with four (4)
1/4-20 x 1/2 truss head bolts, Iockwashers, and
hex nuts. Position bolts from bottom side with
threads upwards on front skirt as illustrated.
Tighten hex nuts securely.
3. Assemble the front support to the lower support
with two (2) 1/4-20 x 1/2 truss head bolts,
Iockwashers and hex nuts. Tighten hex nuts
securely.
//
/
NOTE: It may be necessary to tilt the stand
backwards to tighten the bolts holding the center
support to the lower support.
4. Assemble a rear support to the lower support
with two (2) 1/4-20 x 1/2 truss head bolts,
Iockwashers and hex nuts. Tighten nuts securely.
Do not assemble the rear support to the upper
support at this time. These holes are used in Step
#6 to attach the stand slide bracket.
/
5. Assemble a rear support to each side panel with
four (4) 1/4-20 x 1/2 truss head bolts, lock-
washers, and hex nuts. Tighten nuts securely.
Rear support must touch lower shelf for holes to
line up with front holes.
(3
r-,-
E==
17