Craftsman 113.198610 Owner's Manual page 53

9. CLAMPING FORCE NOT SUFFICIENT AT
MITER ANGLES OTHER THAN 45 °.
a, Miter Lock Handle requires Adjustment.
Refer to Adjusting Miter Lock Handle in Adjust-
ments to Compensate for Wear Section.
10. CLAMPING FORCE NOT SUFFICIENT AT
BEVEL ANGLES OTHER THAN 45 ° .
a. Bevel Lock Handle Requires adjusting.
Refer to Adjusting Bevel Lock Handle in Adjust-
ments to Compensate for Wear Section.
11. DEPTH OF CUT VARIES FROM ONE END OF
WORK PIECE TO THE OTHER.
a. Table Top not parallel with Arm.
Refer to Leveling worktable in Step Two
Alignment Procedure Section.
12. BLADE TENDS TO ADVANCE THROUGH
LUMBER TOO FAST.
a. Dull Blade.
Replace or sharpen blade.
b. Not advancing Saw Blade properly.
Draw Saw Blade across lumber with a slow
and steady pull.
t-
=m
,4-
€
€
i-
o
G
k-
53