Toggle "On/Off" Switch - Craftsman 320.2768 Operator's Manual

3.
5.
6.
Open the motor clamp (A).
With the cutter bit already installed, press ir
the coarse adjustment knob (B), and lower
the motor into the base until the cutter bit is
very close to the flat surface on which the
base is sitting. Turn the fine adjustment dial
(C) until the cutter bit just touches the flat
surface on which the base is sitting. Lock
motor clamp (A).
While continuing to press the coarse
adjustment knob (B), turn the fine
adjustment dial (C) until zero "0" is aligned
with the "l" mark on the base.
7. Release the coarse adjustment knob,
making sure that the "0" remains aligned
with the mark.
8.
Place the router on two level scrap
workpieces and position it so that the
cutter bit can be lowered below the sub-
base. (Fig. 6a).
10. Turn the fine adjustment dial (C) clockwise
to lower the bit to the desired depth of
cut. Turn the dial counter-clockwise to
raise the cutter bit.
11. Once your depth of cut is set, close the
motor clamp (A) securely.
Fig. 6
Fig. 6a
A
NOTE: Making a single deep cut is never
advisable. Smaller diameter cutter bits are
easily broken by too much side thrust and torque. Larger cutter bits will cause a
rough cut and be difficult to guide and control. For these reasons, do not exceed
1/8 in. depth of cut in a single pass.
Fig. 7
TOGGLE "ON/OFF" SWITCH (Fig. 7)
Use the toggle switch located on the top cap
of the motor housing to turn the router "ON"
and "OFF".
The left side of the toggle switch hood (as
you face it) is marked "l" for "On" and the
right side (as you face it) is marked "O" for
"Off". To turn the motor "ON", push the toggle
switch to the left side marked "l", or "On". To
turn the motor "OFF" push the toggle switch
to the right side marked "O", or "Off".
2768 ManuaLRevised_11-0307 Page 19