On/Off Switch; Variable=Speed; Led Worklight - Craftsman NEXTEC 320.35078 Operator's Manual

ON/OFF SWITCH (Fig. 2)
1. Connect the power cord of
your multi-tool to a standard
household power outlet.
2. To turn the tool ON, push the
on/off switch forward.
3. To turn the tool OFF, pull the
on/off switch backward.
VARIABLE=SPEED DIAL (Fig. 3)
The variable-speed feature on this
multi-tool allows you to match the
proper speed to the material being
cut, sawed, scraped or sanded,
enhancing the overall performance
of your tool and helping to save the
application tool from undue wear.
1. The variable-speed dial is
used to adjust the speed of
the application tool.
2. Turn the dial to increase or
decrease the speed of the
tool (Fig. 3).
3. Position "1" selects the
slowest speed; position "6"
selects the fastest speed.
Adjust the application
tool speed for optimum
performance.
NOTICE: Determine the optimum
speed by making a trial cut in a
scrap piece of material.
LED WORKLIGHT (Fig. 4)
Fig. 2
Fig. 3
Variable-speed dial
Fig. 4
LED worklight
The LED worklight, located on
the front of the tool, will illuminate when the on/off switch is in the forward
(ON) position, and will turn off when the switch is pulled backwards (OFF). The
worklight provides additional light for operation in lower-light conditions.
Page 12 35078 ManuaLRevised_12 0615