Troubleshooting; Accessories - Craftsman 320.2768 Operator's Manual

PROBLEM CAUSE SOLUTION
Plug is not plugged into Plug the cord into the power
the power source, source.
Switch is in "OFF"
The router position. Put the switch to "ON" position.
does not work
The carbon brushes Remove the brush caps, and
have worn out replace the old brushes with new
completely, ones.
The surface of The bit is dull. Change to a sharp bit.
the workpiece
is not smooth Routing at an
after cutting inappropriate bit speed Select an appropriate bit speed.
Bit can not be
installed
Bit size is inappropriate
for the collet/nut
Use 1/4-in shaft bits with the
1/4-inch collet; use 1/2-in shaft
bits with the 1/2-inch collet.
_, WARNING: The use of attachments or accessories that are not
recommended for this tool might be dangerous and could result in serious injury.
Sears and other Craftsman outlets offer a large selection of Craftsman router
accessories designed for specific routing applications.
There is a large selection of Craftsman Router Cutting bits available in High-
Speed Steel or Carbide Tipped High-Speed Steel for all your routing needs.
In addition to a wide variety of router bits, Sears also offers accessories such
as: Router tables, various template sets, universal router fence with lock knobs
(64181), 11 pc. bushing set (64180) and clear sub-base sets; 6pc. fixed base
(64182); 6 pc. plunge base (64183).
_1, WARNING: Only use router tables with proper guarding for the cutting bit
and with "on-board" switch-controlled receptacles. Failure to use router tables
with appropriate safety features could result in serious personal injury.
2768 ManuaLRevised_lI-0307 Page 32