Led Worklight - Craftsman NEXTEC HAMMERHEAD 320.30261 Operator's Manual

_, CAUTION: When placing the battery pack in the tool, be sure that the raised
rib on the battery pack aligns with the groove inside the auto-hammer and that
the battery snaps into place properly. Improper assembly of the battery pack
can cause damage to internal components.
TO DETACH BATTERY PACK (Fig. 3}
_I, CAUTION: Avoid the possibility of accidental starting: always take care
not to activate the trigger switch when attaching the battery pack.
1. Depress both battery-release
buttons located on the sides of the Fig. 4
battery pack to release the battery
pack.
2. Pull the battery pack out and
remove it from the tool.
TRIGGER SWITCH (Fig.4)
To turn the hammer on, depress the
trigger switch. To turn it off, release the
trigger.
LED WORKLIGHT (Fig. 5}
The LED worklight, located on the front
of the auto-hammer, will turn on when
the trigger switch is depressed. The
LED worklight will turn off when the
trigger switch is released. This provides
additional lighting on the surface of the
workpiece for operation in lower-light
areas.
FUELGAUGE (Fig. 6)
This tool is equipped with a FuelGauge
which indicates the battery-pack
charge level.
The green LED on the FuelGauge
indicates that the battery is fully
charged.
The orange LED on the FuelGauge
indicates that the battery has used
approximately one half of its charge.
The red LED on the FuelGauge
indicates the battery pack is depleted
and needs to be charged.
Fig. 5
LED worklight
Fig. 6
J
FuelGauge
30261 manuaLRevised_11-0303 Page 13