Wheel Kit Assembly Instructions - Craftsman 580.327140 Owner's Manual

WHEEL KIT ASSEMBLY INSTRUCTIONS
Tools Required:
1. 15/16" box or open end wrench (or socket wrench).
2. 2 13mm wrench, metric box wrench or open end wrench (or socket wrench).
Parts in Wheel Kit Box:
1. 87005A
2. B1760
3. 93728C
4. 94222Q
5. 49808
6. B1764
2
2
2
2
4
1
Retaining Pin
10" Diameter Wheel
Axle Stud
5/8-18 Lock Jam Nut
Flat Washer
Mounting Leg
6
/
4
USE EXISTING FASTENERS
TO SECURE: ITE:H #6
Assembly Instructions:
1. Place the bottom of the generator cradle on a flat, even surface.
2. Place axle stud through wheel retainer on cradle frame.
4. Use wrench to secure the axle stud to frame with 5/8-18 jam nut.
5. Install the other axle stud in the same manner.
NOTE: Be sure to install the wheel with raised hub inboard.
6. Place flat washer over axle stud, tip unit and install the wheel.
7. Retain wheel on axle stud with flat washer and retaining pin. Install other wheel on remaining axle shaft in
the same manner.
8. Remove two front nuts and lock washers from vibration mounting with 13mm wrench. Use these nuts to
retain the mounting leg.
2_