Unpack Generator; Carton Contents; Install Wheel Kit - Craftsman 580.327360 Operator's Manual

Your C raftsman generator requires some assembly and is
ready f oruse only after i t hasbeen p roperly serviced withthe
recommended oiland fuel.
tf youhave anyproblems withtheassembly ofyour
generator,
please call the generator helpliee at
1o800o222o3t 3 6.
Unpack Generator
1. Set the carton on a rigid, fiat surface.
2. Removeeverything from carton except generator.
3. Open carton completely by cutting each corner from top
to bottom.
4. Leavegenerator on carton to install wheel kit.
CartonContents
Check aii contents against those listed below:
o Main unit
o Engine eli
o Operator's manuai
o Wheel kit
o Adapter cord set
If any parts are missing or damaged, call the generator
helpline at 1=800=222=3136.
Install Wheel Kit
NOTE:Wheel kit is not intended for over-the-road use. DO
NOTtow this unit with a motorized vehicle.
You wiii need the foiiowing toois to install these
components:
o 13mm wrench
o Socket wrench with a 13mm socket
o Piiers
. Safety giasses
Install the Wheel Kit as Felbwa:
1. Tip generator so that engine end is up.
2. Slide axie (A) througil both mounting brackets.
3. Placea wheel (B) on each side as shown.
4. Placea washer (C) on axle and then place an e=ring(O)
in axie groove.
5. Instati e=ringwith pliers, squeezing from top of e=ringto
bottom of axle.
CAUTION
E=ringscan cause eye injury.
E=ringscan spring back and become airborne
when instaiiing or removing.
o Alwaysweareyeprotection wheninstalling/removing e -rings.
6. Repeatsteps 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up hobs in support leg (E) with hobs in generator
frame.
9. Attach support ieg using two short capscrews (M8 x
16 mm) (F) and two iocking hex nuts (G). Tighten with
a 13 mm socket and wrench.
10. Return generator to normal operating position (resting
on wheels and support leg).