Unpacking The Generator; Carton Contents; Install Wheel Kit - Craftsman 580.325650 Operator's Manual

Your Craftsman generator requires some assembly and is
ready for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problemswith the assembly of your
generator, please call the generator helpline at
1-800-222-3136.
Unpacking the Generator
f. Set the carton on a rigid fiat surface.
2. Removeeverything from carton except generator.
3. Open carton completely by cutting each corner from top
to bottom.
4. Leavegenerator on carton to install wheel kit.
Carton Contents
Check all contents against those listed below:
• Main unit
• Engine oil
• Oil bottle funnel
• Operator's manual
• Wheel kit
• Adapter cord set
If any parts are missing or damaged, call the generator
helpline at 1-800-222-3135.
install Wheel Kit
NOTE:Wheel kit is not intended for over-the-road use. DO
NOTtow this unit with a motorized vehicle.
You will need the following tools to install these
components:
• 13mm wrenches
• Socket wrench with a 13mm socket
• Pliers
Safety glasses
Install the Wheel Kit as Follows:
IMPORTANT: Installing the wheel kit must be completed
prior to adding any oil or fuel.
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side as shown in A.
4. Place a washer on axle and then place an e-ring in axle
g roove.
5. Install e-ring with pliers, squeezing from top of e-ring to
bottom of axle.
CAUTION
E-tings can cause eye injury.
.,_ E-fings can spring back and become airborne
when installing or removing.
, Alwaysweareyeprotection wheninstalling/removing e -rings.
6. Repeat step 4 and 5 to secure second wheel.
7. Tip generator so that engine side is down.
8. Line up holes in support leg with holes in generator
frame and battery tray bolt.
9. Attach support leg using a capscrew, battery tray bolt
and 2 hex nuts. Tighten with a 13mm socket wrench and
13mm wrench.
10. Return generator to normal operating position (resting
on wheels and support leg).
Axle
<>8
3
Wheel
Capscrew
Axle
Flat Washer
Hex Nut
Support Leg _ Hex Nut
Wheel
E-Ring