Using An Edge Guide - Craftsman 320.28223 Operator's Manual

USING AN EDGE GUIDE (sold separately) (Fig. 20)
An edge guide (sold separately)
is used for straight cutting:
WARNING: Always unplug
the saw from the power source
before making any adjustment
or attaching accessories.
1. Unplug the saw.
2. Insert the bar of the edge
guide through the slots
in the base of the jig saw
(Fig.19). It can be inserted
from either side of the
base, with the edge guide
facing down.
3. Screw the edge guide
locking knob into the
threaded hole in the base
to tighten the edge guide
bar in place.
4. Measure the distance from
the edge of the workpiece to
the line-of-cut. Slide the edge
guide to this desired distance
and then tighten the locking
knob to secure edge guide in
place. (Fig. 21).
Fig. 20
Fig. 21
28223 ManuaLRevised_10 0310 Page 27