Configure Date And Time Manually - HP Surestore 64 - Director Switch User Manual

To disable Periodic Date/Time Synchronization, click the check box to remove the
check mark, then click Activate. To re-enable Periodic Date/Time Synchronization,
click the check box to display the check box, then click Activate.
Click Activate to synchronize the date and time at the next update period. Click the
Sync Now button to synchronize the date and time immediately.
2. Perform one of the following steps:
– To immediately synchronize the director date and time with the HP EFC server, click
the Sync Now button. Make sure that a check mark is in the Periodic Date/Time
Synchronization check box.
If you click Activate, the date and time synchronize at the next update period.
– To synchronize the director date and time with a specific date and time that you
enter:
a. Make sure that Periodic Date/Time Synchronization is disabled (no check). Refer to
Figure 49.
Figure 49

Configure Date and Time Manually

b. Click in a Date or Time field that you want to change.
c. Delete characters and enter new ones as required or highlight the existing character
by dragging the mouse cursor over the character and typing the new character.
d. When entering the hours, use the range of 0 to 23, for minutes and seconds, use the
range of 0 to 59.
Configure Date and Time 131