Setting The Date And Time (Configuration > Library Date/Time); Configuring Network Settings (Configuration > Configure Network Settings) - HP StorageWorks MSL2024 User's And Service Manual

7. If you enabled Sequential mode, you can configure the Autoload and Loop options:
a. Press Previous or Next until the screen displays Autoload Mode Disable or Autoload Mode
Enable. To change the Autoload mode, press Enter. The screen displays either Disable
Autoload Mode or Enable Autoload Mode. Press Previous or Next to toggle between the
enabled and disabled screens. Press Enter to select the Autoload mode. The display shows
the new Autoload mode.
b. Press Previous or Next until the screen displays either Loop Mode Disable or Loop Mode
Enable. To change loop mode, press Enter. The screen displays either Enable Loop Mode or
Disable Loop Mode. Press Previous or Next to toggle between the enabled and disabled
screens. Press Enter to select the loop mode.
Setting the date and time (Configuration > Library Date/Time)
NOTE:
When setting the hours, the time is based on a 24-hour clock. There is no a.m. or p.m. designation.
Use Set Date and Time to set the date and time used to record events. Access to this feature requires
the administrator password.
To set the date:
1. From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2. Press Previous or Next until the screen displays Library Date/Time. Press Enter to select.
3. Enter the administrator password if prompted.
4. The screen displays Set Yr/Month/Day 2006 / 07 / 21 with a flashing number. Press Previous
or Next to change the value of the flashing number. Press Enter to accept the value of the flashing
number and move to the next number.
5. Repeat Step 5 until all numbers in the date are correct. Press Enter.
6. The screen displays (example) Set Hour / Mins 16 : 52 with the first number flashing. Press
Previous or Next until the flashing number reads correctly. Press Enter to move to the next number.
Repeat this step until all numbers in the time are correct. Press Enter.
Configuring network settings (Configuration > Configure Network Settings)
The device can automatically obtain an IP address from a DHCP server when the device is powered
on. The device also supports user-specified fixed addresses through the front panel.
The device also supports SNMP. You can enable SNMP and configure the target addresses with the
RMI. See Changing the network
To configure IPv4 network settings:
1. From the Home screen, press Previous or Next until the screen displays Configuration. Press Enter
to select.
2. Press Previous or Next until the screen displays Configure Network Settings. Press Enter to select.
3. Press Previous or Next until the screen displays IPv4 Networking Enabled. Press Enter to select.
4. Press Previous or Next until the screen displays DHCP Enabled. To change the setting, press Enter.
Press Next until the screen shows the desired setting. Press Enter to accept the new setting.
118 Operating the Tape Library
configuration" on page 88.