2. Select Operating Mode from the Configure menu.
The Configure Operating Mode dialog box displays.
Figure 36
Configure Operating Mode Dialog Box
3. Make sure that Open Systems mode is selected. HP does not support S/390 mode.
4. Select McDATA Fabric 1.0 or Open Fabric 1.0 from the Interop Mode list box.
Figure 37
Configuring Interoperability Mode
Select the interop mode as follows:
– McDATA Fabric 1.0. Select this mode if the director is fabric-attached only to
compatible McDATA switches or FC-64 devices and you require port zoning.
– Open Fabric 1.0. Select this mode if the director is fabric-attached to McDATA
switches, FC-64 devices, or other open-fabric compliant switches. Note that port
zoning is not supported in Open Fabric mode.
5. Click Activate to save your changes and to close the dialog box.
108
Configure Operating Mode