Start The Phone - Ericsson IP Vision Dialog 4425 User Manual

Start the Phone – Log On/Off
20

Start the Phone

Connect the phone to the local network.
See the Installation section,
If an external power adapter is used:
Connect the adapter to the mains and connect the plug from
the adapter to "POWER" on the underside of your phone.
See the Installation section,
After a few seconds the Headset key lamp will light for about five
seconds, then the displays shows:
Settings CallList
User administrator mode to change IP settings
The x indicates a timer counting down seconds. If no key is
pressed during this time, "no change" is selected automatically.
Notes: The administrator mode is used to change the IP
settings of the phone. All administrator mode changes
should be done by your system administrator.
If you want to use the previously stored settings, you can
speed up the procedure by pressing the Loudspeaker key.
Now the display informs you that the phone is connecting to the
server and that the software is loading. This takes about
15 seconds. After a self-test, the phone is ready for log on.
BusinessPhone – Ericsson Dialog 4425 IP Vision
"Install cables" on page 135.
"Install cables" on page 135.
Contacts
?
(No change)
(x)