Telnet Policy States - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Table 5: Telnet Policy States
No policy
Policy with no entries
Policy with entries
To create a telnet policy:
1. From a sectelnet or SSH session, log into the Primary FCS switch as Admin.
2. Enter the following:
3. To save or activate the new policy, enter the secpolicysave or the
primaryfcs:admin> secPolicyCreate "TELNET_POLICY", "192.168.5.0"
TELNET_POLICY has been created.
primaryfcs:admin>
Secure Fabric OS Version 1.0 User Guide
Policy State
Any host can connect by sectelnet or SSH to the fabric.
No host can connect by sectelnet or SSH to the fabric.
Only specified hosts can connect by sectelnet or SSH to the
fabric.
secpolicycreate policy_name, "member;...;member"
Where:
policy_name is TELNET_POLICY.
member is one or more IP addresses in dot-decimal notation. You can
enter "0" in an octet to indicate that any number can be matched in that
octet.
secpolicyactivate command.
If neither of these commands are entered, the changes are lost when you log
out. For more information about these commands, see
Secure Fabric OS Policies" on page 77 and
Fabric OS Policies" on page 77.
Example, creating a telnet policy to allow anyone on a network
"192.168.5.0/24" to access the fabric through a sectelnet or SSH session:
Creating Secure Fabric OS Policies
Description
"Saving Changes to
"Activating Changes to Secure
63