Customizing The Account Passwords - HP StorageWorks MSA 2/8 - SAN Switch User Manual

6. Download the required firmware from the computer to the switch. The
Note:
during the download, which preserves the security policies.
For information about merging fabrics that have Secure Mode enabled, see
Switches and Merging Secure
7. Reboot the switch.
Note:
the first time the switch is booted up.
8. Repeat this procedure for each switch in the fabric.

Customizing the Account Passwords

After installing a new version of Fabric OS, you are prompted to customize the
account passwords at the first login. Until you change the passwords from the
default values, you are prompted to change them each time you log in, and the
passwd command remains disabled.
Note:
accounts, setting the Boot PROM and Recovery passwords is strongly recommended for
Fabric OS v4.1.x (does not apply to v2.6.1 or v3.1.x). For instructions on setting these
passwords, refer to the
3.1.x/4.1.x User Guide
To log in and change the passwords:
1. Open a CLI connection (serial or telnet) to the switch.
2. Log into the switch as Admin. The default password is password.
Secure Fabric OS Version 1.0 User Guide
download process depends on the type of switch and management interface.
Refer to the HP StorageWorks Fabric Operating System Procedures Version
3.1.x/4.1.x User Guide for download instructions specific to the type of switch
and management interface.
If Secure Mode is already enabled on the switch, you can leave it enabled
The PKI objects that are required by Secure Fabric OS are created automatically
In addition to customizing the passwords for the User, Admin, Factory, and Root
HP StorageWorks Fabric Operating System Procedures Version
.
The firmware prompts you to change all passwords.
Fabrics" on page 101.
Adding Secure Fabric OS to the Fabric
"Adding
29