Register Device; Select User Identification - User Code Or Card - Lexmark X642E - X642E Administrator's Manual

2 SafeCom Go Lexmark
2. To avoid a lengthy list of broadcast results, enter the Group name. This
will exclude broadcast results from SafeCom servers that do not belong to
the SafeCom group.
3. Click Broadcast. After 5 seconds the SafeCom server IP address list is
populated with the results of the broadcast.
If the SafeCom server has multiple IP addresses, each address is listed. If
the SafeCom server is clustered you must ensure that the IP address is the
virtual servers and not the IP address of a node.
In a multiserver solution, click Move up and Move down to prioritize the
order in which the servers are contacted in case the first one on the list
becomes unavailable.
4. Click Apply.
Note: After you click Apply it takes approximately one minute before the new
SafeCom Server settings take effect. Wait, otherwise you may get a login error
at the printer.
2.5.3

Register device

1. Open the Register web page (2.4.4).
2. Enter the User logon and PIN code of a user with Technician or
Administrator rights. The user must have a PIN code.
3. Click Register.
Once the device is registered it will appear in SafeCom Administrator. You can
also register the device with the SafeCom solution by:

Using the Add device function in SafeCom Administrator.

Login at the device by a user with Technician or Administrator rights.
2.5.4 Select user identification – User code or card
1. Open the Configuration web page (2.4.2).
2. In the Device pane, go to User identification and select User code,
Card, Card or User code or Card or Windows.
3. Click Apply.
D60711-14 25