Trouble-Shooting And Storage - Image 10.6 Owner's Manual

TROUBLE-SHOOTING AND STORAGE
2O
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance Is needed, call our toll-free HELPLINE at 1-800-
736-6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into
a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 9.) Use only a UL-listed
surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. Various
indicators on the console should light. (See HOW TO TURN ON THE POWER on page 10.)
c. Check the circuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit break-
er has tripped. To reset the circuit breaker, wait for five min-
utes and then press the switch back in.
d. Check the on/off switch located at the front of the treadmill
near the power cord. The switch must be in the "on" position.
Tripped
"On"
Position
Reset
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill near the power cord. If the circuit breaker has tripped (see
the drawing above), wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console. Various indicators on the console
should light.
d. Check to make sure the on/off switch is in the =on" position. (See 1. d. above.)
e. If the treadmill still will not run, please call our toll-free HELPLtNE.
3. SYMPTOM: AN ERROR CODE ("El," "E2," "E3," "E4," OR "E5") APPEARS ON THE CONSOLE
a. If error code "El" appears in the INCLINE display, a malfunction may have occurred in the incline system.
Remove the key, wait for ten seconds, and then reinsert the key. If the error code appears again, call our toll-
free HELPLINE. Do not operate the treadmill until the problem is corrected.
b,
Error code "E2" may appear in the SPEED display if the INCREASE SPEED or PROGRAM START button is
pressed and no movement of the walking belt is detected within seven seconds. Remove the key, wait for ten
seconds, and then reinsert the key, Make sure that you stand on the side rails of the treadmill each time you
start walking belt. If the error code appears again, call our toll-free HELPLINE. Do not operate the treadmill until
the problem is corrected.
c. Error code "E3" may appear in the SPEED display if the speed of the walking belt surges above the selected
speed setting. Remove the key, wait for ten seconds, and then reinsert the key. If the error code appears again,
call our toll-free HELPLINE. Do not operate the treadmill untilthe problem is corrected.
cl. Error code "E4" may appear in the SPEED display if the walking belt is moving at a slow speed, and there is
excessive stress on the motor. Remove the key, wait for ten seconds, and then reinsert the key. If you weigh
over 200 pounds, it may be helpful to increase the incline of the treadmill. If the error code appears again, call
our toll-free HELPLINE Do not operate the treadmill until the problem is corrected.