Image 10.6 Owner's Manual page 6

5. Plug the lower end of the Upright Wire Harness (12) into the
20" Wire Harness (45). The small latch on the Upright Wire
Harness should snap onto the 20" Wire Harness (see the
upper inset drawing). If the Wire Harnesses do not fit together
easily, turn them; do not force the Wire Harnesses together.
Slide the ends of the 12" Cable Looms (36) against the ends of
the Wire Harnesses (12, 45) (see the lower inset drawing). Be
careful not to damage the Wire Harnesses.
12
6. Press the Belt Tool (86) into the opening in the Left Rear
Endcap (82). The use of the Belt Tool is explained on page 21.
7. Attach the Pulse Sensor (14) to one of the Headbands (93 or
107). Make sure that the sensor window is pressed through
the indicated hole in the Headband.
The use of the pulse sensor is explained on pages 7 and 8.
7
Sensor
Window
i, ,,, ,,,, ,
93 or 107
8. Make sure that all parts are tightened before you use the treadmill.
The use of all remaining parts will be explained in other sections of this manual. Note: To protect the floor or
carpet from damage, place a mat under the treadmill