Image 10.6 Owner's Manual page 8

w
The headband must be worn with the sensor win-
dow centered on your forehead (see HOW TO PUT
ON THE PULSE SENSOR on page 7). The small
button next to the sensor window must be
depressed. Make sure that there is no hair in front of
the pulse sensor or between the sensor window and
your forehead. Make-up applied to the forehead
may also interfere with pulse readings.
Note: If the pulse sensor does not detect your pulse
when the sensor window is centered on your fore-
head, try positioning the sensor window above your
dght or left eyebrow. Depending on the shape of
your forehead, your pulse may be detected more
easily from a slightly different position.
4. Avoid turning your head more than 30°away from
the console, or the console may not pick up the
signal from the pulse sensor.
Q
The sensor window should be cleaned weekly when
the treadmill is used regularly. Moisten a cotton
swab with water, and carefully wipe the sensor win-
dow.
6. Because your pulse constantly changes, the pulse
sensor will sample and average your pulse every
few seconds. When you first put on the pulse sen-
sor, it may take up to ten seconds before an accu-
rate pulse is shown.
7. If the pulse sensor does not function properly, check
the batteries (see HOW TO INSTALL BATTERIES
on page 7).
HOW TO CLEAN THE PULSE SENSOR AND
HEADBAND
To clean the pulse sensor, first remove the headband.
Wipe the pulse sensor clean with a damp cloth. Never
Immerse the pulse sensor in water. To clean the
headband, hand wash it in mild detergent, gently wring
it out, and allow it to air dry.