Image 10.6 Owner's Manual page 6

5. Plug theIoworendoftheUpright WireHarness ( 12)intothe
20"WireHamese (45). T hesmag latchon
the Upright wire
Harness should snap onto the 20" Wire Harness (see the
upper Inset drawing), ff the Wire Harnesses do not f_ together
easW, turn them; do not force the wire Harasses together.
Slide the ends of the 12"Cable Looms(36) against the ends of
the Wire Harnesses (12, 45) (see the lower inset drawing). Be
"careful not to damage the Wire Harnesses.
6. Press _e Belt T'o_l (8_"mt6 _h_'opening In the Left Reai;
Endcap"(82). The use of the Belt Tool is explained on page 21.
7. Attach the Pulse Sensor (14) to one of the Headbands (93 or
107). Make sure that the sensor window is pressed through
the indicated hole in the Headband.
The use of the pulse sensor is explained on pages 7 and 8.
7
Sensor
window
93 or 107
Make sure that all pads are tightened before you use the treadmill, The use of all remaining parts will be
explained in other sections of this manual. Note: To protect the floor or carpet from damage, place a mat
under the treadmill.