Assembly - Image 10.6 Owner's Manual

ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until the treadmill Is fully assembled.
Assembly can be completed using the Included 7/32" allen wrench _.
1. Find the Right Upright (15), which contains the Upright Wire
Harness (12) (sea the inset drawing), Hold an Upright Spacer
(25) Inside the lower end of the Right Upright. Insert a 3/8" x
3 1/2" Bolt (27), with one of the four Upright Washers (26), Into
the lower hola in the Right Upright, and through the Updght
Spacer. Slide a Star Washer (49) onto the Boll Finger tighten
the Bolt into the indicated hole in the Frame (50).
Insert a 3/8" x 3 1/2" Bolt (27), with an Upright Washer (26),
through the other hole in the lower end of the Right Upright (15).
Finger tighten the Bolt into the Frame (50).
Attach the Left Upright (not shown) in the same manner.
7 •
26 27
2. Hold the right end of theConsole Crossbar (6) near the Right
Upright (15). Connect the Console Wire Hamess (10) to the
Upright Wire Harness (12). The small latch on the Console
W',ra Harness should snap onto the Upright Wire Hamess (see
the Inset drawing). If the Wire Harnesses do not fit together
easily,, turn them; do not force the Wire Harnesses together.
Slide the ends of the 6" Cable Looms (30) against the ends of
the Wire Harnesses (10, 12). Insert the Cable Looms into the
Right Upright (15). Be careful not to damage the Wire
Harnesses.
2
6
12
30
3. Slide the ends of the Console Crossbar (6) into the Right and
Left Updgh_e(15, 2) as shown. Insert a Console Knob (3) into
each Upright, and thread the Console Knobs into the ends of
the Console Crossbar. Rotate the Console (9) to the desired
angle, and tighten the Console Knobs.
3 9
3
15
4. Tap an Upright Endcap (4) into each of the Uprights (15, 2).
See assembly step 1. Using the included 7/32" allen wrench,
tighten the four 3/6. x 3 1/2" Bolts (27).