Nikon COOLPIX S560 User Manual page 156

_m
D-
z
If the camera fails to function as expected, check the list of common problems
bebw before consuking your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem Cause/Solution []
Monitor is blank
Monitor is hard to read
Camera turns offwithout
warning
Date and time of recording are
not correct
No indicators displayed in
monitor
Date imprint not available
Date not appearing on pictures
even when Date imprint is
enabled
Camera settings reset
Camera is off.
Battery is exhausted.
Standby mode for saving power: press the
shutter-release button halfway.
When flash lamp blinks red, wait until flash
has charged.
Camera and computer are connected via USB
cable.
Camera and TV are connected via AV cable.
Time lapse or interval timer photography in
progress.
Adjust monitor brightness.
Monitor is dirty. Clean monitor.
Monitor has dimmed to save power. Monitor
brightens when controls are used.
Battery is low.
Camera has turned off automatically to save
power.
Battery is cold.
Pictures recorded before clock was set, and
"Date not set" indicator blinks during shooting,
will have time stamp of %0/00/0000 00:00%
movies and voice recordings will be dated "01
01/2008 00:00."
Check camera dock regularly against more
accurate timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Camera clock has not been set.
Date does not appear on movies or on pictures
taken using _., i_i, _ or when Continuous is
set to Continuous or BSS
Backup battery is exhausted; all settings were
restored to their default values.
20
20
15,24
29
82
8O
120
136
15
20
125
135
16
117
120
16,117
35, 38,
3g, 69,
9g
118
142