Table of Contents
Advertisement
• Heated air comes out of the air outlet port. Do not bring your hands or
face, or objects which cannot withstand heat close to this port, otherwise
burns or damage could result.
Replacement of the lamp unit should only be carried out by a qualified
technician.
• The lamp unit has high internal pressure. It can easily become damaged if
struck against hard objects or dropped, and injury or malfunctions may
result.
When replacing
the lamp, allow it to cool for at least one hour before
handling
it.
• The lamp cover gets very hot, and contact with it can cause burns.
Before replacing
the lamp, be sure to unplug the mains lead from the
power outlet.
• Electric shocks or explosions can result if this is not done.
Caution
De not cover the air inlet or the air outlet.
• Doing so may cause the projector to overheat, which can cause fire or
damage to the projector.
De not set up the projector in humid or dusty places or in places where
the projector may come into contact with smoke or steam.
• Using the projector under such conditions may result in fire or electric
shocks.
When disconnecting the mains lead, hold the plug, not the cord.
• If the mains lead itself is pulled, the cord will become damaged, and fire,
short-circuits or serious electric shocks may result.
Always disconnect all cables before moving the projector.
• Moving the projector with cables still attached can damage the cables,
which could cause fire or electric shocks to occur.
De not place any heavy objects
on top of the projector.
• Failure to observe this may cause the projector to become unbalanced
and fall, which could result in damage or injury.
Do not short-circuit, heat or disassemble the battery or place it into
water or fire.
• Failure to observe this may cause the battery to overheat, leak, explode or
catch fire, and burns or other injury may result.
When inserting the battery, make sure the polarities (+ and -) are
correct.
• If the battery is inserted incorrectly, it may explode or leak, and fire, injury
or contamination of the battery compartment
and surrounding area may
result.
ENGLISH-7
Advertisement
Table of Contents
