Table of Contents
Advertisement
More than 1800 hours
Morethan2000 hours
(Thelampwill turnoff
automatically about10 minutes
afterturningon the power.)
On-screen display
Displayed for 30
seconds. Pressing any
button will clear the
display.
This display cannot be
cleared at all, no matter
which button is pressed.
Lamp indicator warning
light
LAMp
©
/i
\
The lamp indicator
illuminates red even if
the projector is in
standby mode.
Lamp unit replacement
procedure
NOTE:
• If the lamp usage time has passed 2000 hours (when LAMP POWER has
been set to "HIGH"), the projector will switch to standby mode after
approximately 10 minutes of operation. The steps _) to O on the next
page should thus be completed within 10 minutes.
_Turn
off the MAIN POWER
switch according to the
procedure given in "Turning
off
the power" on page 23, and
then disconnect the power
cord plug from the wall outlet
and check that the area around
the lamp unit has cooled down.
Use a Phillips screwdriver to
turn the lamp unit cover fixing
screws at the bottom of the
projector, and then remove the
lamp unit cover from the
projector.
Lamp unit cover
_===y
Lamp unit cover
fixing screws
Use a Phillips screwdriverto loosen
the two lamp unit fixing screws until
the screws turn freely. Then hold
the handle of the lamp unit and
gently pull it out from the projector.
Lamp unit fixing screws
©
©
°!
oo
Ha_ die
_lnsert
the new lamp unit while
making sure that the direction
of insertion is correct, and then
use a Phillips screwdriver to
securely tighten the lamp unit
fixing screws.
ENGLISH-55
Advertisement
Table of Contents
