Panasonic PT-AE200E Operating Instructions Manual page 56

_lnstall the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screws.
NOTE:
• Be sure to install the lamp unit
and the lamp unit cover securely.
If they are not securely installed,
it may cause the protection circuit
to operate so that the power
cannot be turned on.
®Insert the power cord plug into
the wall outlet and then press
the MAIN POWER switch.
NOTE:
• If the POWER button on the
projector does not illuminate red
when the MAIN POWER switch is
turned on, turn the MAIN POWER
switch off again and check that
the lamp unit and the lamp unit
cover are securely installed. Then
turn the MAIN POWER switch
back on.
Press the POWER button so
that a picture is projected onto
the screen.
® Press the MENU button to
display the MAIN MENU
screen, and then press the •
and • buttons to move the
cursor to select "OPTION".
.MENU
_KEYSTONE
_--qPICTURE
[_qPOSITION
m SHUTTER
_.VOLUME
[4_ LANGUAGE
SD MENU
# SELECT ENTER
Press the ENTER button to
display the OPTION screen,
and then use the • and •
buttons to select LAMP
RUNTIME.
OPTION
OSD _ ON
NR _ ON
PC PRIORITY _NORMAL
BACK COLOUR _BLACK
_CENTRE
_FRONT
U_SK/CEILING _ DESK
FAN CONTROL _NORMAL
LAMP POWER _ HIGH
'_SE LECT _C
Press and hold the ENTER
button for approximately 3
seconds.
OPTION
osn _ ON
NR _ ON
PC PRIORITY _NORMAL
BACK COLOUR _BLACK
4:3 H-POS _CENTRE
FRONT/REAR _FRONT
D_SK/CEILING _ DESK
FAN CONTROL _NORMAL
LAMP POWER _ HIGH
m.
# SELECT _C
The "LAMP RUNTIME" will
change to "TIME RESET
[POWER OFF]".
NOTE:
• If the MENU button is pressed,
the lamp time resetting screen
will be cancelled.
@Turn off the power.
This will reset the cumulative
usage time for the lamp unit to
zero.
Refer to page 23 for details on
how to turn off the power.
56-ENGLISH