Maintenance And Cleaning - Welch Allyn ABPM 6100 Hardware Manual

5. Maintenance and Cleaning

Preventative maintenance should be routinely performed to ensure the safe and efficient
operation of the ABPM 6100 monitor. In addition, the monitor should be cleaned after each
use.
Maintenance
The following inspections of the ABPM 6100 unit should be performed on a regular basis:
•
The PC connection cable should be inspected for any cracks, exposed wires or other
damage.
•
The monitor itself should be visibly inspected for any signs of damage.
•
Pneumatic tubing should be inspected for any cracks, fraying, or kinks.
•
Do not remove any covers or break the warranty seal while inspecting the unit.
If any signs of damage are detected, do not use the ABPM 6100 monitor. It should be sent
to an authorized Welch Allyn service center. See the Service and Warranty section of this
manual for a list of authorized Welch Allyn service centers.
Cleaning
CLEANING THE ABPM 6100 UNIT
IMPORTANT: The ABPM 6100 cannot be sterilized. DO NOT immerse the
monitor in any fluid or use liquid detergents, cleaning agents, or
solvents to clean it. If the unit is immersed in any liquid, do not use the
unit again. The unit should be sent to an authorized Welch Allyn service
center.
The ABPM 6100 unit should be cleaned after every use. Use a soft, damp cloth to remove
any dirt and dust from the unit.
DISINFECTING THE CUFF
A mild disinfectant solution should be used on the cuff. Do not remove the nylon bladder
inside of the cuff during this process.
If you are using a Welch Allyn sleeve cuffs, you can easily remove bladders to aid in
washing and disinfecting. Sleeve cuffs are machine washable.
DIR 80012720 Ver. B
ABPM 6100 Hardware Manual
20 / 30