Welch Allyn ABPM 6100 Hardware Manual page 18

4. Click "Next"
5. Click "Yes" if you agree with the license agreement.
6. Click "Next"
7. Click "Finish"
8. Insert the Keyspan Adapter into an available USB port.
9. The driver will load automatically after few seconds. When the light on the adapter
flashes at a constant rate (~1 sec interval) the device is ready.
Note: If you plan to remove this on a regular basis. Mark the port that it is plugged
into. If you plug it into a different port it will install a different COM port and the
program may not function correctly.
10. To determine which COM port was assigned by the Keyspan Serial Assistant
assigned to the device click "Start"
DIR 80012720 Ver. B
ABPM 6100 Hardware Manual
18 / 30