Panasonic Omnivision VHS PV-4564 Operating Instructions Manual page 26

Check the following points once again if you are having
some trouble with your VCR.
No power...
TV program can't be recorded...
Timer recording can't be performed...
There is no playback picture, or the playback picture _snoisy
or contains streaks...
During special effects playback, the picture may contain
some vertical jitter when using a TV which has an Automatic
Vertical Hold Control...
If the top of your playback picture waves back and forth
excessively...
• Check that the Power Plug is completely cofH_ected to
an AC outlet.
• Check that the POWER button is set to on.
• Check the connections between the VCH, tiq_ externad
antenna, and your TV.
• Check that the band selected matches your antenna or
cable -IV system. (P.6)
• Make sure that the record tab on the back of the
cassette is still intact. (P.23)
$
Set the recording start/stop times correctly. (P.12)
Make sure that the POWER button is set to off. (P.12)
Timer recording may not be performed or continued if a
power interruption of more than 1 minute occurs before,
or during, Timer Recording, even if power resumes
thereafter.
• Select the same channel on your TV as that of the
Channel 3/4 switch located on the rear panel of the
VCR. (Separate Connection Guide)
• Set the VCR/TV selector to "VCR". (P.9)
• Check that channel 3 or 4 of the TV is properly adjusted.
• Adjust the TRACKING control slowly in either direction.
(P.g)
• Set the TV's Vertical Hold Control to "MANUAL" and
then adjust it.
• Because the VCR playback signal is not as stable as an
off-the-air TV signal, the top of your TV screen may be
bent or unstable during playback. To solve this problem,
slowly turn the horizontal hold control on your TV to
correct the wavy picture. If your TV does not have a
horizontal hold control or adjusting the control does not
help, please contact your local TV service center.
26