Table of Contents
Advertisement
PROBLEM
CAUSE
SOLUTION
Fuses or circuitbreakers open
frequently.
1. Motor isovedceded.
2. Fuses or circuit breakers are
wrong size or defective.
I. Feed work more slowly.
2. Replace fuses or circuit break-
era,
3. Dull blade.
3. Replace the blade.
Saw vibrates excessively.
4, Start switch is defective,
1, Blade is warped.
4. Have the switchreplaced.
1, Replace the blade.
2. Belt is damaged.
2. Replace the belt.
3. Saw is not mounted securely.
3. Tighten all hardware.
4, Work surface is uneven.
4. Repesition on a fiat surface.Ad-
just the levelingfeet on legs.
Start switch does not operate.
1. Switch contacts are burned out,
1. Have the switch replaced and ra-
quest a voltage check from the
power company.
2, Capacitor is defective
2, Have the capacitor replaced,
3. Connectionsare loose or dam-
3. Have the widng checked and ra-
aged.
paired.
Handwheels are herd to turn.
1, Sawdust has collected on the
1. Clean and lubdoatethe mecha-
mechanism inside sew.
nism.
Blade does not lower when turning
height handwheel.
1. Blade lock handle is not fully
1. Fully release the blade lock
released,
handle.
Mitergage does notmove smoothly.
1. Miter gage assembly is dirty or
1, Raleasethe mitergage knoband
sticky,
wax the miter gage base and
sides.
Cut binds,bumsor stalls motorwhen
ripping.
1, Blade or teeth are dull.
2. Blade is heeling,
1. Sharpen or raplasethe blade.
2. See Heelingthe Sawblade in the
Adjustments section,
3. Board iswarped.
3. Raplacethe board.
4, Ripfencedoeenotperallalblede.
4, SeaAligningtheRipFenoaintha
Assembly section.
Saw bladedoes not cuttrue at 90 ° or
45 ° positions.
1. Indicators are not properly ad-
justed.
2. Positive stops inside base are
not accurate.
1, See Setting the Bevel Stopsand
Indicator in theAdjustmentssec-
tion.
2. Sea Setting the Bevel Stops and
Indicator inthe Adjustmentssec-
tion.
45
I:IUlFTSHRN TABLESAW315,2283_
Advertisement
Table of Contents
