REMOVING
I REPLACING
THE THROAT
PLATE
See Figure 44.
_k
WARNING:
Make sure the switchis off, the
switch key is removed, and your saw is
unplugged.Failure to do so could result in
accidental starting,resulting in sadous personal
injury.
• To remove the throat plata, first loosen the screw in
the throat plate with a phillipsscrewdriver and lift
the front end. Pull it out toward the frontof the saw.
•
To re-installthe throat plate, place it in the opening.
Push it toward the rear of saw base to engage the
springclip.
Note: The keyslot in the throat plata will drop over the
screW.
•
Check that the throat plate is even withthe table
top. If not, adjustthe four sat screws with a 2
mm hex key. See the procedure in the Assam-
b/y section.
•
Securelytightenthmat plata screw. Do not allow
the throat plate to bow up above the table surface.
THROAT PLATE
KEYSLOT
SPRING CUP
TABLE
Fig. 44
CRRFI"SHH N"TABLE SAW31S.2283gO
34