Table of Contents
Advertisement
Note: The right side of saw is on your dght when
facing the saw, as if you were in normal
operating position,
INSTALLING
THE REAR RAIL
See Figures 12- 14.
_k
WARNING:
Front and rear rails must be
installedand carefully aligned to reducethe risk
of kickback, Kickback can result in serious injury.
•
From the carton, remove the mar rail pieces and
the followinghardware:
6 squarehead bolts(5/16-18 x I in,)
6 fiat washers (5/16 in,)
6 hex nuts (5/16-18)
Rear rail connector
Right and left end caps for rear rail
2 screws (#8-32 x 112 in.)
Note: Remaining hardware from this hardware beg is
used for installingthe front rail and end caps.
• At the back of the table, put the square head bolts
in the holes in the edge of the saw table and the
outer holes in each extensiontable so the bolt
heads extend outward 112 in.
•
Under the table, loosely attach washers and hex
nutsonto bolts. Slide the slot on the rear rail over
the bolts.Adjust each bolt to fit the rail closelyto
the table.
•
Position right rail (longest piece) so that right hand
edge extends 2-1/2 inches beyondtable extension.
•
Push right rail against table and tighten each nut
with a 12 mm wrench. If rail jams and does not
slide easily over bolts, re-align table extensions.
• Put the end caps on rail ends. Insert the screws
and tighten with a phillipshead screwdriver.
TABLE
SLOT
EXTENSION
REARRAIL
SQUARE
HEADBOLTS
REAR RAIL
CONNECTOR
WASHER
TABLE
REARRAIL
Fig. 13
END CAP
SQUARE
HE)(NUT
HEADBOLTS
FLAT
WASHER
Fig, 12
21
SCREW
REAR OFSAW
Fig. 14
CRRFTSMRN'I"ABLE SAW31_2283S0
Advertisement
Table of Contents
